It is a special non-standard equipment for the production of wave tooth composite gasket and metal tooth gasket. It is specially used for the production and processing of the concave convex angle of wave tooth composite gasket and metal tooth gasket. It is a new production process for the production of wave tooth composite gasket and metal tooth gasket. In the past, the production of wave tooth composite gasket and metal tooth gasket was carried out on a general lathe with a certain fixture and processing procedure. There are many, laborious, time-consuming and materials consuming. The utilization rate of raw materials is low, and there are many waste materials in the lower corner. Especially in the production and processing of corrugated tooth composite gasket and metal tooth gasket with large diameter, ordinary lathe can not process them, and large vertical lathe is required to process and produce them, which is more difficult to process, and increases the processing cost of production cost. However, this equipment adopts new production technology, which reduces the production of corrugated tooth composite gasket. Cost of sheet and metal serrated gasket.
Main technical parameters:
Voltage: 380V50Hz speed regulating motor: 0.75KW speed: 0 ~ 1320 rpm
Cylinder diameter: 40mm cylinder stroke: 100mm driving axle wheel: 100mm
Thickness of ring: 3mm processing range: above DN300
Note: it can produce and process 2 mm, 4 mm, 5 mm thick corrugated metal ring.