It is a special non-standard equipment for producing wave tooth composite gasket and metal tooth shape gasket. PLC numerical control system, hydraulic system. It is a new production technology for producing wave tooth composite gasket and metal tooth gasket. In the past, the production of wave tooth composite gasket and metal tooth gasket was carried out with a certain fixture on the general lathe, and the processing procedures were many, laborious, time-consuming, material consuming, and the utilization rate of raw materials was low. There are a lot of angular scraps. Especially in the production and processing of wave tooth composite gasket and metal tooth gasket with large diameter, ordinary lathe can't process them, and large vertical lathe is needed to process them. It's more difficult to process them. It also increases the processing cost of production cost. However, this equipment adopts new production technology, uses ordinary turning tools for processing and production, which reduces the production wave (lower than the cost of using special milling tools). The cost of tooth composite gasket and metal tooth gasket. The production process is fully automatic.

Main technical parameters:

Voltage: 380V50Hz adjustable speed motor: 1.5kw 0 ~ 1320 rpm

Oil cylinder diameter: 50mm oil cylinder stroke: 100mm driving axle wheel: 100mm

Thickness of ring: 2, 3, 4, 5mm processing range: above DN300